Results 1 to 2 of 2

Thread: BRI interface channel config

  1. #1
    matthew Guest

    Default BRI interface channel config

    Just want to confirm before I have a new service provisioned from my carrier.
    What channel configuration does the Warp require on an ISDN2 connection, point to point or point to multipoint?
    This service will have a 100 number direct indial range attached.


  2. #2
    skar Guest


    The BRI interfaces on the WARP support both point to point and point to multi point. The default value is set to point to point but it is only a change in a config file to make it run point to multi point.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts