Results 1 to 2 of 2

Thread: aohtest script to test receiving calls on one span of E1

  1. #1
    epretlac Guest

    Default aohtest script to test receiving calls on one span of E1

    Question: Can you give me a simple set of aohtest commands that would be the minimum to get one span of EuroISDN E1 running to test ISDN startup and receiving of a call ?

    Solution: This script should do the trick. If you copy this into a file called isdn_rcv.txt you can then run it from the aohtest command line using the following:

    > script isdn_rcv.txt

    # -------------------------------------------------------
    # Script: isdn_rcv
    # Parameters:
    # inttype - {e1|t1} specifies the type of interface to configure the framers for
    # numchans - number of channels that will be in use for the test
    # Sample script invocation:
    # script isdn_rcv.txt inttype=t1 numchans=192
    # This script will configure a dual-board system to receive incoming
    # calls from a remote computer.

    # Configure the logging masks to output relavent log messages
    log set masks api=0xffffffff isdn=0xffffffff span=0xffffffff

    # Configure the physical devices
    board 0 open
    board 0 set config interface=e1 clockmode=slave
    span 0 open
    isdn 0 open 0
    isdn 0 set config node=client
    isdn 0 set config switch=net5 country=euroisdn

    # Start the framers and wait until the ISDN groups linkup
    isdn 0 start
    span 0 start
    wait 20000

    # Restrict the console output to important messages only
    isdn 0 set verbosity level=important

    # Indicate that channels should autoanswer incoming calls
    # Change channel range to match no. of ISDN licenses you have
    # For example, if you have licenses for 1 span of ISDN (30 channels) use
    # channel 0-29 seize
    # channel 0-29 set config behavior=autoanswer
    channel 0 seize
    channel 0 set config behavior=autoanswer
    Last edited by epretlac; 02-16-09 at 02:34 PM. Reason: update to script (channel 0-29 seize)

  2. #2
    eurovoice Guest


    Some additional useful information ...

    a) If you're using this script for debugging and want to see all messages logged, remove the line that says "isdn 0 set verbosity level=important"

    b) Note that AoH Test scripts need the first span to be called Span 0. When you come to write your app, the AoH/HMP api numbers spans from 1 (as shown on the back of the card).

    c) If you place your script in a different directory, you will need to use '\\' as the directory delimiter. e.g. if the script is saved in the C:\ directory, run
    > script C:\\isdn_rcv.txt

    Hope that helps ...

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts