Search:

Type: Posts; User: Rodb

Search: Search took 0.00 seconds.

  1. Thread: Full of Questions

    by Rodb
    Replies
    7
    Views
    7,798

    Hi Cody, The whole PADS sw package + FreePBX...

    Hi Cody,

    The whole PADS sw package + FreePBX GUI can be downloaded (FREE) from the Warp community site: www.pikawarp.org. Using a USB Flash Key, its very easy to upgrade the software package....
  2. Thread: Full of Questions

    by Rodb
    Replies
    7
    Views
    7,798

    Hi Cody, There were audio issues early on with...

    Hi Cody,

    There were audio issues early on with the Warp and echo, but with the patches released on PADS 2.0 and the latest PADS 2.1 Maintenance Release, there have not been any reports of Audio...
  3. Replies
    0
    Views
    4,131

    dialparties.agi process use 80% - 95 % CPU time

    dialparties.agi process use 80% - 95 % CPU time

    There are several articles on the net talking about process load of dialparties.agi process so this issue is not unique to the Warp.

    There are...
  4. Replies
    2
    Views
    3,958

    FreePBX - Configuring a BRI Interface

    The procedure to add a BRI trunk is very similar to adding a FXO trunk.

    1) In the left-hand column click on 'Trunks' and then select 'Add a Custom trunk' on the screen.

    2) In the 'Custom Dial...
  5. Thread: Fan noise

    by Rodb
    Replies
    2
    Views
    2,903

    There is a way to check the temperature of the...

    There is a way to check the temperature of the unit via the following shell command:

    cat /sys/bus/i2c/devices/0-004a/temp1_input

    The resulting value is the temperature in Celcius * 1000.
  6. Thread: Fan noise

    by Rodb
    Replies
    2
    Views
    2,903

    Hi Martin, It could either be the Fan / sensor...

    Hi Martin,

    It could either be the Fan / sensor has failed or the software has changed the behaviour.

    Could you try loading the previous image again to rule out that it's the hardware that is...
Results 1 to 6 of 6