View Full Version : Warp + BRI

06-26-12, 10:54 AM
Currently I 'm testing a warp with a bri module installed. Inbound calling is working, but outbound calling is not working right now. Is there a howto available? I've searched the internet, and found something with pika.conf. But on my new warp there is no such file. Please give me a hint for starting in the right direction.

Error on the asterisk console: "TRUNK Dial failed due to CHANUNAVAIL HANGUPCAUSE: 66 - failing through to other trunks"

06-26-12, 11:10 AM
Warp v2 will not have a pika.conf file present. And Warp v2 will have a product number of PIK-99-00920 on a sticker on the bottom of the unit. Are you using FreePBX? In your particular case it sound like the device name being used in the 'Dial' application may be incorrect.

06-26-12, 11:11 AM
In the case of Warp v2, documentation on the Internet for Asterisk Dahdi or FreePBX setup can be followed directly for the most part.
All specific resources for Warp v2 can be found at http://warpwiki.pikatech.com
Documentation can be found at http://warpwiki.pikatech.com/bin/view/Main/UserDocumentation
In your case if you are using FreePBX then you will want to specifically look at the 'WARP for Asterisk User Guide'. Contained in here is a section on 'Adding Trunks' and 'Adding Routes'.

For anything not contained in the documentation we would recommend posting to the forum where it can be answered.

06-27-12, 01:16 PM
Thanks, it's up&running. It is a Warp v2, so with the right manual it was easy to setup.