View Full Version : PIKA WARP with bri card and Fxo Card

02-20-11, 09:08 AM

Is it possible to have in the same pika warp a fxo module and a bri module ?

Else can we change the fxs port ,included in the pika warp, in fxo by software command ?

Best Regards,

02-21-11, 11:25 AM
No, it is not possible to have a FXO and BRI module (configured to TE) in the same Warp. But it is possible to have a FXO and BRI module (configured to NT) in the same Warp.
The on-board FXS port is only a FXS port and cannot the changed to anything else.

02-24-11, 11:14 AM

In France we have a fxs port on the modem adsl, which allow the free call to the landline and french mobile phone.
May you use this device so as to wire this fxs to pika warp's fxs ?


Best Regards,

02-24-11, 05:54 PM
Interesting little device. I don't see a reason this would not work to provide dialtone access to the PSTN. I would however imagine this will provide immediate connection to the network - in other words, there would be no capability to perform call progress analysis for answer or disconnect suprevision.