PDA

View Full Version : BRI interface channel config



matthew
08-12-09, 08:31 PM
Hi
Just want to confirm before I have a new service provisioned from my carrier.
What channel configuration does the Warp require on an ISDN2 connection, point to point or point to multipoint?
This service will have a 100 number direct indial range attached.

Regards,
Matt

skar
08-12-09, 11:11 PM
The BRI interfaces on the WARP support both point to point and point to multi point. The default value is set to point to point but it is only a change in a config file to make it run point to multi point.